Crazepony® 4pcs Emax MT2213 935kv Brushless Motor （2CW 2CCW） with Orignal 1045 Propellers for DJI F450 F550 Quad Hex Octo Copter

Nothing beats these motors. Nothing. Over 200 hours and they run like the day i installed them. Still tight bearings. Don't ever waste money on other cheap junk that comes out the box lose bearings and rough spin..crash after crash 35 min run times. These motors take the abuse. emax is the shiso as good as tiger motors hands down. If you have ever put 200 hours on a 2212 or 2213 motor then you can talk. I have them on 4 drones never had a problem with one!! These are the chevy 350 small block of the drone world. Or for you ford guys the 5.0.. my 400 quad with 9443 props at 2lbs with a 3ah 4 cell at 40c does 80mph for 15 minutes. My 500 quad with a 3 cell 6.2ah on 1045 props 3.8lbs camera drone does 45mph for 15 minutes with these motors

I was under the impression that the nuts on top would be self tightening after they are hand tightened, after doing a couple takeoff-landing practice runs the nuts on top loosened quite a bit, so make sure you tighten them firmly (and yes the nuts are on in the correct fashion with CW and CCW motors). For the price you really can't beat the value of getting the motors with extra propellers. I put the product on a RipaFire 450 frame and everything seems to be running smoothly.

Misleading advertisement. States you will get two CW and two CCW motors. Picture in ad clearly shows two motors with red prop nuts and two motors with black prop nuts indicating rotation. First received order contained 4 motors with red prop nuts that all tightened in the same direction. Returned and reordered only to have the second package identical to the first. I can still use them by swapping the wiring of two motors, but there is a possibility that the nuts will loosen in flight. Will try a different brand next time.

Pretty good moters better customer service. Moters are good they have a lot of bearing noise but still pretty good. The props they come with are garbage get new ones. I have about 5 hours on the moters and they still go strong. The company is the best part of this deal they are fast to respond and with make it all good if there are any problems. If your in question with any products from them don't hesitate crazypony is great with all of there products.

Might just be bad luck but one motor doesn't work right. I got it to work for a little bit by making sure the wires coming out of the motor were pushed towards one side but never got the quadcopter to really fly with it. The motors that work seem to have lots of power so I'm hoping with a replacement I get a little bit of flying time with them. I couldn't recommend anyone buy them based on this order though.

Good quality motors at a good price! I'm glad they came with the female bullet connectors if I had to do soldering, but I ordered an ESC (Afro 30A SimonK, can be found on hobbyking) that already had female connectors attached. The props were good and withstood a few small crashes, but not outstanding. It's also good that they came with the screws to mount the motors, and the mount spaces are 16mm and 19mm apart, which works perfectly with my reptile 500 frame.

Please disregard my earlier comments. The motors are fine. The mounting hole alignment is different between the cw motors and the ccw motors.

Motors seem smooth, only used very short time as I have crashed the drone lol, think little sand in motor but seem ok for now. I may need to order replacements but will buy these, because the build quality I think is pretty good